The process of garage door opener installation is normally simple, although manufacturers and parts may vary. Garage door openers are often offered in a Do it yourself kit to be installed by the buyer, so as expected it comes with extremely clear step-by-step instructions and materials that are labeled clearly for easy identification.
It's a simple and easy process of installation that would not take too much time to complete.
Build the Opener. Lay out all parts like the directions suggest. Parts are usually stamped or will contain lettered stickers. The first step is to assemble the rail. Next you may connect it to the opener's motor head. Once you have assembled all the pieces to complete th opener, you can then install it.
Attach the Rail to the Header. A ladder around 8 foot in dimension is required to carry out this step of the installation. Raise your garage door and mark it at the highest tip. Close the garage door. Exactly a couple of inches coming from the marked spot, create another mark, this is where you would be placing the header bracket bottom. Use the wooden lag bolts to secure the header bracket in the second mark.
With the motor end on the floor and the rail inside the header bracket, line up the opener assembly on the garage door. The holes on the rail have to be in line with the header bracket. Slide a clevis pin into the bracket and rail to attach.
Mount the Motor. Position the ladder behind the garage door tracks, in the center. Position the motor on the ladder. Little by little, lift up the garage door until it comes in contact with the door. At the same time as you continue to open the door, the motor assembly is going to be lifted off the motor. A 2x4 wood must then be placed in between the garage door and opener rail once the door is opened fully.
To carry out your garage door opener installation properly, you'll need to attach the hangers to the motor head and into the ceiling stuffs. Using the directions and hangers given, connect them to the ceiling using lag bolts. After attaching the hangers, lift the motor head and bolt it to the ceiling hangers.
Connect the Opener and the Door and Controls. Close up the garage door. Fasten the longer section of the opener arm to the opener carriage assembly. Fasten the other section to the garage door. Next hold the arms together and adjust them based on the directions.
Now verify if the garage was pre-wired for installation of the photo-electric eye and wall station. Low-voltage wires at the bottom of the door track, by the entrance from the home, and by the opener motor is an indication of this.
You can without doubt do pre-wiring in case the garage is not yet pre-wired. Directions are given for this procedure. As soon as wiring is finished, connect the photo-electric eye to the exterior of the garage door entrance. Utilize the insulated staples to attach the wires to the ceiling as well as the walls. Do not forget to leave some cables unattached to use for the opener.
Author Resource:-
If you want to learn more info on garage door opener installation, don't wait and visit John Defoe's best online resource site on installing a garage door opener and other garage door instalation problems to learn all the facts and check where to get information.
![[Valid RSS feed]](http://www.articlelog.com/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites